TVS ECU Software Stage 2 – for VAG vehicles fitted with the DQ250 MQB gearbox, 2013+
The first real step into increased performance! By extracting the maximum performance from a stock engine setup, while remaining within all safety limits! This level of tuning is based on 98 RON fuel, but tuning is available for other fuel grades.
TVS ECU Software Stage 2 highlights:
- Custom TVS Stage 2 ECU calibration.
- Data analysing and fine tuning.
- Dyno run and dyno sheet.
- Engine and Gearbox Diagnostics.
- Improved temperature protection - enhanced engine cooling and oil temperature management.
- Ability to remove vehicle speed limiters.
- Motorsport rev limiter (hard cut) - As well as adjust the point of the limiter.
- Diesel Particulate Filter (DPF) / Exhaust Gas Recirculation (EGR) / Lambda-O2 Delete (decat) - deactivation.
- Exhaust Crackle / Over run / Decel.
- Intake Swirl flaps delete.
- Cylinder On Demand (COD) / Active Cylinder technology (ACT) / Start-Stop Removal.
- Map sensor scaling.
- Upgraded injector calibration.
- Improved fuel economy.
TVS ECU Stage 2 software optimises the performance of the VAG MQB platform vehicles, with the following engines: 2.0 T(F)SI, 2.0 TDI, 3.2-3.6 V6, 1.9 TDI, 1.4 TSI and 1.8 TSI (2013 - Present).
While the VAG platform is known to be generally strong, reliable and easy to use, there is some room for improvement, even without performance hardware, which can be extracted with the use of the TVS ECU Stage 2!
Please note: The TVS ECU Stage 2 software is designed specifically for stock vehicles. If your vehicle has performance hardware added, please check out the Stage 2 to Stage 4 TVS ECU tuning options.
TVS Software must be installed at either PERON HQ or any of our UK Dealers premises. This software is not currently available as a home-flash service.
